Beehives & Their Parts

Made from Pine tree or tilia tree. With four holes in each end bar for passing the wire and the foundation

Replacement doors for ANEL mobile bottom board. A set of two doors come with an ANEL bottom board, but can also be bought separately. Suitable for securing the entrance during transport, as well as for protecting the entrance. Prevent bugs larger than 8 mm from entering the hive. They even offer protection against small yellow wasps, as they provide a "fortified" position for defence. Equipped with special pin on the back, locking them in place so that they remain stable during transport. No further securing required. To open, slightly pull the handle and then push upwards. You can leave one door open and the other closed, limiting the entrance of the hive. Available in yellow and blue, thus limiting disorientation of bees.

To install the disk, you must open a 30-40mm hole on the beehive side. The disk is installed on the hive by passing a screw through the disc center. It features 4 positions/“settings”: (i) completely closed, (ii) completely open, (iii) bee queen excluder and (iv) protection from hornets. TIP: Can be used for multiplication and merging of colonies. Making a 4 cm hole and installing two discs on a wooden sheet with same dimensions as the beehive, allows you, by changing disc “settings” to use the structure for queen separation (exclusion) and merging of colonies: first leave the discs at “completely closed” position with ventilation for 1-2 days, allowing the transfer of smell between the two colonies; then turn both discs to “queen excluder” position, thus allowing communication of the bees, while the queens keep giving birth without being able to contact/harm each other (since the discs/excluders are placed in between the two different floors created by the installation of the wood/disc structure).